Transfer Case; Transmission; Double Cardan Joint; Transfer Cae Drain And Fill Plugs - Jeep J-10 Series 1982 Technical & Service Manual

LUBE
FITTINGS
90143
Fig. B-20 Double Cardan Joint
Check manual or power steering gear assembly for
leaks, housing cracks or loose frame mounting. Inspect
steering damper for leaks or loose mounting. Also, check
steering tie rods and connecting rod for bending, loose
ness or wear.
9. Check Windshield Washer Fluid Level
Check fluid level with each fuel fill.
10. Transfer Case—Fluid Level Check
Fluid levels in the transfer case must be checked as
scheduled. To check lubricant level, remove the transfer
case fill plug located on the rear of the transfer case.
Lubricant should be level with the fill plug hole (figs.
B-21 through B-23). If not, bring up level with specified
lubricant and install fill plug. Refer to Recommended
Fluids and Lubricants chart located at the end of this
chapter for lubricant specification and to Fluid Capaci
ties chart for transfer case capacity.
DRAIN
Fig. B-21 Transfer Case Drain and Fill Plugs—Model 300
MAINTENANCE B-13
BSBl
FILL
DRAIN
Fig. B-22 Transfer Case Drain and Fill Plugs—Mods) 208
FILL
DRAIN
Fig. B-23 Transfer Case Drain and Fill Plugs—Quadra-Trac
Transfer Case—Fluid Change
Drain and change transfer case at scheduled interval.
To change fluid:
(1) Remove fill plugs then drain plugs.
(2) Allow transfer case to drain completely.
(3) Install drain plugs.
(4) Fill with specified lubricant to level of fill hole.
(5) Install fill plugs.
CAUTION: Do not overtighten fill and drain plugs.
Tighten plugs to 15 to 25 foot-pounds (20.3 to 33.9 N9m)
torque. Overtightening can strip threads or break the
aluminum case.
11. Transmission
Refer to Engine Components for procedure on check
ing fluid level for automatic transmission.
Fluid levels in the transfer case and manual transmis
sion must be checked at the same time, as scheduled. Fill
plugs for all manual transmissions are located on the
right side of the assembly.
To check lubricant level, remove the transmiyyu n fill
plug. Lubricant should be level with each fill plug hole.