Chassis Illustration; Lubrication Points - Jeep J-10 Series 1982 Technical & Service Manual

B-4 MAINTENANCE
1982 JEEP ENGINE MAINTENANCE (Continued)
Miles (Thousands)
Kilometers (Thousands)
Months
Each
Fuel
Fill
5 12.5 20
27.5 30
35
42.5 60
8 20 32 44 4a 56 68 80
5 12.5
20 27.5 30 35 42.5 50
Check Ignition Timing
♦
Check Ignition Timing
a • a
Replace Spark Plugs
•
Replace Oxygen Sensor (4-Cylinder California)
a
Reset Oxygen Sensor Signal (4-Cylinder California)
a
Replace Charcoal Canister Air Inlet Filter (8-Cylinder) I
•
a Required 4 Recommended. But Not Required
® Change coolant initially at 12.500 mi (20000 km) or 12% months, whichever comes first, then at the start of eech winter season. Maintain a 50/50 mixture of
coolant and water (-34°F/ -36°C Freezing Point) for cooling system corrosion protection during the summer season.
% Replace air cleaner element once in between each normally scheduled change under heavy duty driving conditions - particularly driving predominantly on dusty
roads.
* On 6-Cylinder models, clean PCV filter in air cleaner. On 8-Cylinder models, clean PCV(ilter in oil filler cap.
0 LUBRICATION POINTS
BRAKES
Fig. B-4 Chassis Illustration
Perform the maintenance services at the intervals shown. The symbol tells you what service is required, followed by the time and/or distance interval.
For example: Front Wheel Bearings (Number 2) should be lubricated every 30,000 miles (48 000 km) under normal use, and every 15,000 miles
(24 000 km) under heavy-duty operation. (The footnotes provide additional information about certain components and services.)