Suzuki WagonR+ RB310 Service Manual page 2099

1B-20 AIR CONDITIONING (OPTIONAL)
INSTALLATION
Reverse removal sequence to install cooling unit, noting the follow-
ing points.
D If cooling unit or evaporator is replaced, pour 25 cc of refrigerating
oil to compressor suction-side.
D Install uniformly the padding (1) to installation hole.
D Evacuate and charge system according to previously described
procedure.
D Adjust heater control cable, refer to HEATER CONTROL LEVER
ASSEMBLY in HEATER AND VENTILATION section.
D Enable air bag system, if equipped.
A/C EVAPORATOR THERMISTOR
Check resistance between evaporator thermistor (1) terminals.
Sensor Temperature (_C (_F))
0 (32)
25 (77)
If check results are as not specified, replace evaporator thermistor.
NOTE:
When the evaporator thermistor removed, its should be rein-
stalled in original position.
Resistance (kΩ)
6.3 – 7.0
1.8 – 2.2