Belt Tensioner Assembly
Removal
CAUTION
Be sure to wear necessary safety equipment to prevent accidents when repairing.
Try to prevent body paint surface from being scratched during removal and installation.
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the engine trim cover assembly
4. Remove the accessory drive belt
5. Remove the belt tensioner assembly.
a. Remove the fixing bolt from belt tensioner assembly,
and remove the belt tensioner assembly (1).
(Tightening torque: 40 + 5 N·m)
Inspection
1. Rotate tensioner assembly by hands and check if the rotation is smooth and if abnormal noise occurs.
2. Wiggle tensioner assembly in the axial and radial direction to check the bearing for looseness.
3. Check if there is damage on tensioner assembly operating surface.
Installation
Installation is in the reverse order of removal.
CAUTION
After installation, turn crankshaft with a wrench to run accessory drive belt several circles, and check if
crankshaft turns smoothly and belt runs well. If it does not turn smoothly, reinstall the accessory drive
belt.
Make sure to install accessory drive belt in place, and not interfere with other components.
Chery Automobile Co., Ltd.
(See page
10-10).
(See page
07-24).
07 - SQR484F ENGINE MECHANICAL
1
RT21070060
07
27
07–