Chery T21 2014 Service Manual page 678

14 - SQR484F IGNITION SYSTEM
ON-VEHICLE SERVICE
High-voltage Cable
Removal
CAUTION
 Be sure to wear necessary safety equipment to prevent accidents when repairing.
 Try to prevent body paint surface from being scratched during removal and installation.
 It is prohibited to use short circuit spark test to test ignition function during repair; otherwise it may cause
personal injury and damage the module.
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the engine trim cover assembly
4. Remove the high-voltage cable.
a. Disconnect the high-voltage cables (arrow) for each
cylinder in order from the ignition coil, and move the
high-voltage cable on the ignition coil side to one side.
14
b. Remove 3 high-voltage cable clips (arrow).
c. Loosen the high-voltage cables (1) in order and pull
them upward to remove them from the spark plug
holes.
d. Remove the high-voltage cable.
CAUTION
 Be careful not to damage the high-voltage cables when pulling them upward.
8
14–
(See page 10-10).
Chery Automobile Co., Ltd.
RT21140020
1
RT21140030