1
Attire
2
Vehicle Protection
3
Safety Operation
Preparation for Tools and
4
Measuring Gauge
Removal and Installation,
5
Disassembly and
Assembly Operations
6
Removed Parts
Chery Automobile Co., Ltd.
Always wear a clean uniform.
A hat and safety shoes must be worn.
Before starting work, prepare radiator grille cover, fender cover, seat
cover and floor mat.
When working with two or more persons, be sure to check safety each
other.
When working with engine running, make sure to provide ventilation
for exhaust gas in workshop.
If working on high temperature, high pressure, rotating, moving, or
vibrating parts, be sure to wear appropriate safety equipment and take
extra care not to injure yourself or others.
When jacking up vehicle, be sure to support the specified location with
a safety stand.
Use appropriate safety equipment to lift vehicle.
Before starting work, prepare a tool stand, special tools, gauge, oil and
replacement parts.
Diagnose after thoroughly understanding the proper service
procedures and reported problem.
Before removing parts, inspect the general condition of assembly to
check for any deformation or damage.
Take notes for the complicated assembly. For example, note the total
number of electrical connections, bolts, or hoses that are removed.
Add matchmarks to ensure that each component is assembled to its
original position. Temporarily mark the hoses and their joints as
necessary.
Clean and wash removed parts as necessary and assemble them
after a thorough inspection.
Place the removed parts in a separate box to avoid mixing them up
with new parts or contaminating new parts.
For non-reusable parts such as gaskets, O-rings, and self-locking
nuts, replace them with new ones as instructed in this manual.
Retain removed parts for customer inspection, if requested.
02 - INTRODUCTION
02
5
02–