Chery T21 2014 Service Manual page 557

Activated Charcoal Canister Assembly
Removal
CAUTION
 Be sure to wear necessary safety equipment when repairing to prevent accidents.
 Try to prevent body paint surface from being scratched during removal and installation.
 Before removal, mark fuel vapor pipe II, fuel vapor pipe I and charcoal canister breather pipe to avoid
confusion.
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Raise the vehicle to the proper position.
4. Remove the activated charcoal canister assembly.
a. Pull out the charcoal canister breather pipe (1) from
body hole.
b. Remove the coupling bolt (arrow) between activated
charcoal canister assembly and body
(Tightening torque: 7 ± 1 N·m)
c. Remove the activated charcoal canister assembly
from body bracket in the direction of arrow as shown
in the illustration.
d. Loosen the elastic clamps (arrow), disconnect the
connection between hose and activated charcoal
canister assembly, and remove the activated charcoal
canister assembly.
e. Loosen the elastic clamp (1), remove the charcoal
canister breather pipe from activated charcoal
canister assembly.
CAUTION
 Positioning distance from hose end to elastic clamp is 3 - 5 mm.
Chery Automobile Co., Ltd.
09 - SQR484F EMISSION CONTROL SYSTEM
1
1
09
RT21090060
RT21090070
9
09–