DTC Code
DTC Definitions
Ign./Distributor Eng.
P0322-00
Speed Inp. Circ. No
Signal
DTC Confirmation Procedure
Confirm that battery voltage is over 12 V before performing the following procedures.
Turn ignition switch to LOCK.
Connect X-431 3G diagnostic tester (the latest software) to Data Link Connector (DLC).
Turn ignition switch to ON.
Use X-431 3G diagnostic tester to record and clear the DTCs stored in the ECM.
Select Read Code.
If the DTC is detected, the malfunction indicated by the DTC is current. Go to the diagnosis
procedure - Step 1.
If DTC is not detected, the malfunction indicated by the DTC is intermittent
CAUTION
When performing circuit diagnosis and test, always refer to the circuit diagram for specific circuit and
component information.
Diagnosis Procedure
1
Check ECM ground point
a. Turn ignition switch to LOCK.
b. Check ECM grounds E-026 and E-028
Repair or replace ground wire harness or
NG
ground point
Chery Automobile Co., Ltd.
06 - SQR484F ENGINE MANAGEMENT SYSTEM
DTC Detection
Conditions
Engine speed sensor
Flywheel gear ring
Engine running
Wire harness or connector
ECM
(See page
06-18).
Possible Cause
(See page
06-18).
OK
107
06–
06