19 - CLUTCH
5. Install the release fork (2).
6. Install the release bearing (1).
Bleeding Hydraulic Clutch
WARNING
Brake fluid is harmful to your skin, be sure to wear protective gloves before operation.
Once brake fluid contacts with your skin, wash it off with water immediately.
CAUTION
Collect brake fluid with a container.
DO NOT allow brake fluid to spray onto body surface. Brake fluid may damage the painted surfaces. If
any brake fluid is get onto the painted surfaces, wash it off with water immediately.
Only use brake fluid recommended by Chery Automobile Co., Ltd, otherwise the lines may be subjected
to a severe corrosion.
Brake fluid type should be DOT4.
HINT:
An assistant will be required to assist when bleeding hydraulic clutch.
1. Turn off all the electrical equipment and ignition switch.
2. Check the fluid level in brake master cylinder, add DOT4 brake fluid as necessary, and keep the cap open.
CAUTION
19
Make sure that there is sufficient brake fluid in reservoir before bleeding.
3. Raise the vehicle with a lifter.
4. Remove the discharge port protective cap and connect a
clear plastic hose to the bleeder screw, and submerge
the end of hose into the clear container which is full of
new brake fluid.
16
19–
1
2
Chery Automobile Co., Ltd.
RT21190170
RT21190260