Chery T21 2014 Service Manual page 15

8. Lubrication and seal
Use seal gum and gasket based on the position.
If seal gum is applied, install components before the seal gum dries to prevent leakage.
Apply lubricant to the movable area and friction area of components.
During assembly, apply permitted lubricant or grease to the specified area (such as oil seal).
9. Adjustment
Use proper meter and tester for adjustment.
10.Pre-coated parts
Pre-coated parts are the bolts and nuts that are coated
with seal lock adhesive in the factory.
If a pre-coated part is retightened, loosened, or moved in
any way, be sure to reapply the specified adhesive.
11. Rubber parts and rubber hoses
Avoid gasoline or oil dripping on the rubber parts or rubber hoses.
12.Hose clamp
Before removing hose, observe the position of clamp so
as to reinstall it to the same position.
Replace the deformed or dented clamps with new ones.
When reusing a hose, fix the clamp on the clamp track
portion of hose.
For elastic clamp, push tabs in the direction of arrow as
shown in the illustration after installation to widen the tabs
slightly.
13.Vise
When using vise, install protective plates on the jaws of
vise to prevent parts from being damaged.
Chery Automobile Co., Ltd.
02 - INTRODUCTION
Seal Lock Adhesive
Elastic Clamp
Clamp Track
02
RT21020060
RT21020070
RT21020080
9
02–