07 - SQR484F ENGINE MECHANICAL
CAUTION
Pay attention to the front marks of piston and connecting rod during assembly without being reversed.
Install them with the side stamped with letter "481HK" on the connecting rod and piston top arrow facing
toward timing belt side as shown in the illustration.
07
7. Install the connecting rod bearing cap.
HINT:
The direction of the number on one side of connecting
rod is the same as that of the number on the connecting
rod bearing cap. These numbers are cylinder numbers
indicating at which cylinder are located. For example,
number 3 indicates that the mounting position is at No.3
cylinder.
a. Install the connecting rod bearing cap in place, and
screw the connecting rod bearing cap fixing bolts
(arrow) by hands, then tighten the connecting rod
bearing cap fixing bolts in two steps.
(Tightening torque: 1st step: tighten to 25 ± 3 N·m;
2nd step: retighten for 90° ± 5°)
CAUTION
Apply a small amount of engine lubricant to the connecting rod, connecting rod bearing cap and thread
joint surface.
8. Other assembly is in the reverse order of disassembly.
98
07–
3
3
Chery Automobile Co., Ltd.
RT21071270
RT21071280
RT21070950