Clutch Pedal
Removal
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the clutch switch
4. Remove the clutch pedal.
a. Remove the fork retainer (1), pull out the center pin
(2) and disconnect the clutch master cylinder push rod
(3) from clutch pedal.
b. Remove 3 nuts (arrow) from clutch.
(Tightening torque for nut: 25 ± 2 N·m)
c. Remove the clutch pedal.
Installation
Installation is in the reverse order of removal.
CAUTION
Make sure to adjust clutch pedal to standard height before installation.
Be sure to tighten nuts to specified torque.
Check fluid level in reservoir after installation.
Chery Automobile Co., Ltd.
(See page
19-8).
19 - CLUTCH
2
1
3
RT21190080
RT21190090
19
9
19–