Table of Contents
Advertisement
15 - SQR484F STARTING SYSTEM
Check for Open
Multimeter
Connection
H-002 (18) -
H-004 (2)
H-002 (10) -
H-004 (1)
Check for Short
Multimeter
Connection
H-002 (18) or
H-004 (2) - Body
ground
H-002 (10) or
H-004 (1) - Body
ground
H-002 (18) or
H-004 (2) -
Battery positive
H-002 (10) or
H-004 (1) -
Battery positive
Repair or replace front right door wire
NG
harness and connector
15
5
Confirm DTCs
a. Connect related wire harness connectors.
b. Connect the negative battery cable.
c. Turn ignition switch ON.
d. Connect X-431 3G diagnostic tester to Data Link Connector (DLC) to check if any DTC is detected.
System operates normally
OK
6
Reconfirm DTCs after replacing front door handle sensor (built-in low frequency antenna)
a. Remove the front left door handle sensor (built-in low frequency antenna)
b. Remove the front right door handle sensor (built-in low frequency antenna).
c. Replace front left/right door handle sensors (built-in low frequency antenna) with new ones.
d. Connect X-431 3G diagnostic tester to Data Link Connector (DLC) again to check if any DTC is detected.
28
15–
Specified
Condition
Condition
Always
Continuity
Always
Continuity
Specified
Condition
Condition
Always
No continuity
Always
No continuity
Always
No continuity
Always
No continuity
+
-
1
2
3
3
4 5 6
6
7 8 9
9
10 11 12
12
13 14 15
15
16
17
18
18
H-002
2
1
H-004
(See page
37-56).
Chery Automobile Co., Ltd.
2
1
5
4
8
7
11
10
14
13
17
16
RT21150240
OK
NG
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
