06 - SQR484F ENGINE MANAGEMENT SYSTEM
Check for Short
Multimeter
Connection
E-084 (1) or
E-035 (16) - Body
ground
E-084 (1) or
E-035 (16) -
Battery positive
Repair or replace wire harness or
NG
connector (upstream oxygen sensor -
ECM)
06
6
Check upstream oxygen sensor
a. Remove upstream oxygen sensor.
b. Check upstream oxygen sensor for following problems.
Moisture enters the internal of sensor, temperature changes greatly, and probe is broken.
Oxygen sensor is "poisoned" (Pb, S, Br, Si, etc.).
Replace upstream oxygen sensor
NG
7
Check for DTCs
a. Use X-431 3G diagnostic tester to read the ECM DTC.
b. Refer to "DTC Confirmation Procedure".
c. Check if DTC P0130-00, P0131-00, P0132-00, P0133-00, P0134-00, P2195-00 or P2196-00 still exists.
Replace ECM
NG
System is operating normally.
Reassemble vehicle and perform a road test to confirm that malfunction reported by customer has
been repaired.
74
06–
Specified
Condition
Condition
Always
No continuity
Chery Automobile Co., Ltd.
OK
OK
OK