06 - SQR484F ENGINE MANAGEMENT SYSTEM
DTC Code
System Voltage
P0560-00
Malfunction
System Voltage Low
P0562-00
Voltage
System Voltage High
P0563-00
Voltage
DTC Confirmation Procedure
Confirm that battery voltage is over 12 V before performing the following procedures.
Turn ignition switch to LOCK.
06
Connect X-431 3G diagnostic tester (the latest software) to Data Link Connector (DLC).
Turn ignition switch to ON.
Use X-431 3G diagnostic tester to record and clear the DTCs stored in the ECM.
Select Read Code.
If the DTC is detected, the malfunction indicated by the DTC is current. Go to the diagnosis procedure - Step 1.
If DTC is not detected, the malfunction indicated by the DTC is intermittent
CAUTION
When performing circuit diagnosis and test, always refer to the circuit diagram for specific circuit and
component information.
Diagnosis Procedure
1
Check battery
a. Check if battery voltage is normal.
Recharge or replace battery
NG
2
Check battery terminals
a. Check if battery terminals are loose or corroded.
Tighten or replace battery terminals
NG
140
06–
DTC Detection
DTC Definition
Ignition switch ON
Condition
Fuse
Wire harness or connector
Battery
Battery terminal
ECM
Chery Automobile Co., Ltd.
Possible Cause
(See page
06-18).
OK
OK