Chery T21 2014 Service Manual page 735

4
Check brake switch assembly
a. Remove the brake switch assembly
b. Check the brake switch assembly.
Using ohm band of digital multimeter, check for continuity
between terminals of brake switch assembly according to
the table below.
Multimeter
Condition
Connection
Brake pedal
Terminal 1 -
depressed (switch
Terminal 3
pin released)
Brake pedal
Terminal 2 -
depressed (switch
Terminal 4
pin released)
Brake pedal
Terminal 1 -
released (switch
Terminal 3
pin pushed)
Brake pedal
Terminal 2 -
released (switch
Terminal 4
pin pushed)
Replace brake switch assembly
NG
5
Confirm DTCs
a. Connect related wire harness connectors.
b. Connect the negative battery cable.
c. Turn ignition switch ON.
d. Connect X-431 3G diagnostic tester to Data Link Connector (DLC) to check if any DTC is detected.
Repair or replace PEPS controller
NG
System operates normally
Chery Automobile Co., Ltd.
(See page 27-9).
Specified
Condition
Continuity
No continuity
No continuity
Continuity
15 - SQR484F STARTING SYSTEM
+ -
1 2
3 4
RT21260300
OK
15
OK
51
15–