Chery T21 2014 Service Manual page 952

18 - QR019CHB CVT
Secondary Shaft Pressure Sensor
Removal
1. Turn off all the electrical devices and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the air filter
4. Disconnect the wire harness connector of the secondary
shaft pressure sensor (arrow).
5. Remove the secondary shaft pressure sensor (1).
(Tightening torque: 15 - 22 N·m)
Installation
Installation is in the reverse order of removal.
CAUTION
 Keep clean of sensor and contact surface between sensor and transmission, and avoid dust or impurity
18
entering the transmission.
 During installation, apply automatic transmission fluid on the O ring of the sensor.
118
18–
(See page 10-17).
1
Chery Automobile Co., Ltd.
RT21180420
RT21180430