Chery T21 2014 Service Manual page 929

DTC Code DTC Definition
Pressure Control
P0960 Solenoid 'A' Control
Circuit Open
Pressure Control
P0962 Solenoid 'A' Control
Circuit Low
Pressure Control
P0963 Solenoid 'A' Control
Circuit High
DTC Confirmation Procedure:
Confirm that battery voltage is between 11 and 14 V before performing the following procedures.
 Turn ignition switch to LOCK.
 Connect X-431 3G diagnostic tester (the latest software) to Data Link Connector (DLC), and make it
communicate with vehicle electronic module by the data network.
 Turn ignition switch to ON.
 Using X-431 3G diagnostic tester to record and clear the DTCs stored in the TCU.
 Turn ignition switch to LOCK and wait for a few seconds.
 Turn ignition switch to ON, and then select "Read Code".
 If DTC is detected, the malfunction indicated by the DTC is current. Go to the diagnosis procedure - Step 1.
 If DTC is not detected, the malfunction indicated by the DTC is intermittent. Please refer to Intermittent
DTC Troubleshooting.
Diagnosis Procedure
HINT:
After the fault is eliminated, verify DTC and symptom again.
1
Check wire harness connector
a. Turn ignition switch to LOCK.
b. Disconnect the transmission wire harness connector.
Chery Automobile Co., Ltd.
DTC Detection
Condition
The solenoid
output feedback
voltage is
normal, oil
pressure control
solenoid 'A'
feedback current
is less than the
standard value
The solenoid
output feedback
voltage is
normal, oil
Start engine and wait pressure control
for at least 3 seconds solenoid 'A'
feedback current
is higher than the
standard max
value
The solenoid
output feedback
voltage is
normal, oil
pressure control
solenoid 'A'
feedback current
is less than the
standard value
18 - QR019CHB CVT
DTC Set
Possible Cause
Condition
 Solenoid circuit
open circuit or
short circuit
 Oil pressure
control solenoid 'A'
failure
18
95
18–