Chery T21 2014 Service Manual page 588

10 - SQR484F INTAKE SYSTEM
Intake Manifold Assembly
Removal
CAUTION
 Temperature of hood is very high when engine is running. Before removal, make sure engine has
stopped running and hood has cooled down, otherwise, there is a risk of scald injury.
 Be sure to wear necessary safety equipment when repairing to prevent accidents.
 Try to prevent body paint surface from being scratched during removal and installation.
1. Release fuel system pressure
2. Turn off all the electrical equipment and ignition switch.
3. Disconnect the negative battery cable.
4. Remove the engine trim cover assembly
5. Remove the fuel rail injector assembly
6. Remove the electrical throttle assembly
7. Remove the trim cover front bracket
8. Remove the intake manifold assembly.
10
a. Pull out the line assembly with PCV valve assembly
from the PCV valve rubber boot in the direction of
arrow as shown in the illustration.
b. Loosen the elastic clamp (1) and disconnect the
connection between vacuum booster hose and intake
manifold assembly.
c. Loosen the elastic clamp (2) and disconnect the
connection between canister solenoid valve outlet
hose and intake manifold assembly.
d. Remove the intake manifold bracket fixing bolt
(arrow). 
(Tightening torque: 18 ± 2 N·m)
24
10–
(See page 08-10).
(See page 10-10).
(See page 08-26).
(See page 10-20).
(See page 10-11).
1
2
Chery Automobile Co., Ltd.
RT21100230
RT21100240