Chery T21 2014 Service Manual page 662

13 - SQR484F LUBRICATION SYSTEM
Oil Cooler Assembly
Removal
WARNING
 DO NOT disconnect oil cooler inlet hose and oil cooler outlet hose until engine is in low temperature.
Otherwise, overheated engine coolant and steam with high-pressure may flow out and cause serious
personal injury.
 If your body contacts coolant accidentally, clean it with water immediately. If it is serious, please go to
hospital.
 DO NOT remove oil filter and oil cooler assembly until engine cools down.
 Prolonged and repeated contact with engine oil will be harmful to your skin. If engine oil spills on your
skin, wash it off immediately with water. In addition, the used engine oil contains potentially harmful
contaminants, which may cause skin cancer. Therefore, always take proper skin protection measures
when performing vehicle service.
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the engine lower right protector assembly
4. Drain the engine oil
5. Remove the oil filter
6. Remove the oil cooler assembly.
a. Loosen the elastic clamp (1) and disconnect the
connection between oil cooler outlet hose and oil
13
cooler assembly.
b. Loosen the elastic clamp (2) and disconnect the
connection between oil cooler inlet hose and oil cooler
assembly.
c. Using an appropriate tool, loosen the oil filter joint
(arrow).
(Tightening torque: 50 ± 5 N·m)
CAUTION
 After disconnecting oil cooler outlet hose and oil cooler inlet hose, cover the hoses with wooden corks or
equivalent to prevent coolant in hoses from flowing out.
d. Remove the oil filter joint (1) and oil cooler assembly
(2) in order.
18
13–
(See page 13-11).
(See page 13-13).
(See page 48-29).
Chery Automobile Co., Ltd.
2
1
RT21130130
2
1
RT21130140