Renault Laguna III Manual page 2398

MECHANICAL COMPONENT CONTROLS
Clutch circuit: Removal - Refitting
TL4
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 415, 02A, Lifting equip-
ment).
a Disconnect the battery (see Battery: Removal - Re-
fitting) (MR 415, 80A, Battery).
a Remove:
- the air filter box (see Air filter unit: Removal - Re-
fitting) (MR 415, 12A, Fuel mixture),
- the bolt (1) from the max fuse box.
a Move the max fuse box.
LEFT-HAND DRIVE
a Remove:
- the engine undertray bolts,
- the engine undertray.
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Remove the bleed plug (2) .
a Connect a transparent pipe to the bleed hole running
to an empty container placed under the bleed hole.
a Push and hold the metal clip (3) .
a Pull out the hydraulic clutch control pipe by one
123036 notch to release the bleed opening.
a Release the metal clip.
a Depress the clutch pedal with your hand (to drain the
reservoir, the master cylinder and the clutch pipe).
a Push and hold the metal clip (3) .
a Disconnect the hydraulic clutch control pipe from the
slave cylinder.
a Insert the plugs into each opening.
37A-64
37A
116806