Renault Laguna III Manual page 2217

4-wheel steering actuator: Removal - Refitting
4-WHEEL STEERING
II - REFITTING OPERATION FOR PART
CONCERNED
a Ensure:
- the position of the four wheel drive actuator (14) ,
- the routing of the wiring (15) ,
- the position of the actuator (16) linkage on the com-
pensator,
- the position, head down, of the actuator bolts (17) .
a Refit the four wheel drive actuator by starting with
the linkage on the rear axle side and then on the
compensator side.
REAR AXLE COMPONENTS
128340
128484
a Clip the wiring strap.
a Attach the actuator wiring on the fuel tank.
a Connect the connectors.
a Refit the earth strap.
a Tighten to torque:
- the four wheel drive actuator's new nuts (84
N.m),
- the earth strap nut (8 N.m).
a Refit the ball joint protector.
III - FINAL OPERATION
a Refit the fuel tank.
a Tighten to torque:
- the fuel tank bolts (21 N.m),
- the fuel tank neck's earth bolt (21 N.m).
a Refit:
- the underbody protectors,
- the silencer heat shield,
- the automatic parking brake control unit support,
- the silencer (see Silencer: Removal - Refitting)
(19B, Exhaust).
a Torque tighten the bolts on the automatic parking
brake control unit support (21 N.m).
a Connect the battery (see Battery: Removal - Refit-
ting) (80A, Battery).
a Check the geometry of the axle assemblies (see
30A, General information, Axle assemblies:
Check, page 30A-19) .
33A-50
33A