Renault Laguna III Manual page 1957

Hydraulic distributor: Removal - Refitting
M9R, and AJ0
a
Note:
Check to ensure that the seals for the intercooler
air inlet pipe are fitted in their groove the right
way round.
a Refit new joints to the intercooler air inlet pipe.
a Turn the intercooler air inlet pipe clips until they are
refitted in their groove.
a
Note:
The intercooler air inlet pipe is correctly clipped
onto the turbocharger and the intercooler when
the clips are engaged in the groove of the turbo-
charger and the intercooler.
a Clip the intercooler air inlet pipe onto the turbocharg-
er and the intercooler.
a Refit the bolts on the intercooler air inlet pipe.
a Tighten the bolts on the intercooler air inlet pipe.
a Fit the cooling hose onto the intercooler air inlet
pipe.
a Refit the nut for the cooling hose onto the intercooler
air inlet pipe.
a Tighten the nut for the cooling hose on the intercool-
er air inlet pipe.
a Refit:
- the front end panel (see Front end panel: Remov-
al - Refitting) (42A, Upper front structure),
AUTOMATIC GEARBOX
115069
- the headlights (see Headlight: Removal - Refit-
ting) (80B, Headlights),
- the front bumper (see Front bumper: Removal -
Refitting) (55A, Exterior protection),
- the front wheel arch liners (see Front wheel arch
liner: Removal - Refitting) (55A, Exterior protec-
tion),
- the front wheels (see Wheel: Removal - Refitting)
(35A, Wheels and tyres),
- the battery tray (see Battery tray: Removal - Re-
fitting) (80A, Battery),
- the battery (see Battery: Removal - Refitting)
(80A, Battery).
a Fill and bleed the cooling system (see Cooling sys-
tem: Draining - Refilling) (19A, Cooling).
a Fill the automatic transmission (see 23A, Automatic
gearbox, Automatic gearbox oil: Draining - Fill-
ing, page 23A-29) .
a Refit the engine undertray.
a Apply the after repair procedure using the Diagnos-
tic tool :
- connect the Diagnostic tool,
- select « Gearbox computer » ,
- go to repair mode,
- display the « before/after repair procedure » for the
computer selected,
- select « Hydraulic distributor » in the section « List
of components controlled by this computer » ,
- carry out the operations described in the « After re-
pair procedure » section.
23A-39
23A