Renault Laguna III Manual page 1960

Hydraulic distributor: Removal - Refitting
F4R, and AJ0
REFITTING
I - REFITTING PREPARATION OPERATION
a Clean the joint faces using SURFACE CLEANER
(see Vehicle: Parts and consumables for the re-
pair) (04B, Consumables - Products) on the auto-
matic gearbox and on the hydraulic distributor
housing, taking care not to damage the contact sur-
faces.
a Always replace:
- the hydraulic distributor O-rings,
- the hydraulic distributor housing seal.
- the intercooler air inlet pipe seal.
II - REFITTING OPERATION FOR PART
CONCERNED
a Refit the new hydraulic distributor O-rings.
a Tilt the hydraulic distributor slightly when refitting it in
order to engage it with the automatic gearbox lever
(6) .
a Connect the internal wiring connector.
a Torque tighten the hydraulic distributor bolts (8
Nm).
III - FINAL OPERATION
a Refit:
- a new hydraulic distributor housing seal,
- the hydraulic distributor housing.
AUTOMATIC GEARBOX
117254
a Torque tighten the hydraulic distributor housing
bolts (8 Nm).
a Remove the air inlet pipe seal of the intercooler us-
ing a tweezers.
a
Note:
Check that the intercooler air inlet pipe seal is fit-
ted in its groove the right way round.
a Refit a new seal to the intercooler air inlet pipe.
23A-42
23A
115068
115069