Renault Laguna III Manual page 2195

Rear stub axle carrier: Removal - Refitting
4-WHEEL STEERING
a Align the marks on the eccentric bolt and rear axle.
a Check the positioning of the eccentric bolts and ec-
centric washers in their guides.
a Tighten to torque:
- the new nut of the eccentric bolt of the stub axle
carrier while aligning the marks (190 N.m),
- the lower bolt of the stub axle carrier (190 N.m),
- the new nut of the ball joint of the con rod (37
N.m).
III - FINAL OPERATION
a Refit the brake disc protector.
a Torque tighten the brake disc protector bolts (8
N.m).
a Refit:
- the rear brake disc (see 33A, Rear axle compo-
nents, Rear brake disc: Removal - Refitting,
page 33A-15) ,
- the brake calliper mounting (see 33A, Rear axle
components, Rear brake calliper mounting: Re-
moval - Refitting, page 33A-13) ,
- the rear brake pads (see 33A, Rear axle compo-
nents, Rear brake pads: Removal - Refitting,
page 33A-3) .
a Clip:
- the brake hose,
- the wheel speed sensor wiring,
- the wheel speed sensor.
a Refit the rear wheel (see 35A, Wheels and tyres,
Wheel: Removal - Refitting, page 35A-1) .
a Connect the battery (see Battery: Removal - Refit-
ting) (80A, Battery).
a Check the axle geometry (see 30A, General infor-
mation, Axle assemblies: Check, page 30A-19) .
a Adjust the rear axle, if necessary (see 30A, General
information, Rear axle system: Adjustment, page
30A-32) .
IMPORTANT
T o avoid any accident, bring the pistons, brake
pads and brake discs into contact by depressing
the brake pad several times.
REAR AXLE COMPONENTS
33A-28
33A