Front Axle System: Adjustment - Renault Laguna III Manual

Front axle system: Adjustment

Tightening torquesm
wheel alignment adjust-
ment lock nuts
Note:
Throughout the axle assembly checking and adjust-
ment process:
- the Renault Card must remain in the reader,
- do not press the « START » button.
ADJUSTMENT PREPARATION STAGE
a Check the geometry (see 30A, General informa-
tion, Axle assemblies: Check, page 30A-19) .
1 - Wheel alignment
a Adjust the wheel alignment by rotating the track rod
sleeves.
a Loosen the wheel alignment adjustment lock nut (1)
.
a Turn the track rod sleeve (2) to the required value.
a After adjustment, torque tighten the wheel align-
ment adjustment lock nuts (53 N.m).
2 - Castor angle
a Not adjustable.
GENERAL INFORMATION
53 N.m
122722
3 - Camber
a Not adjustable.
4 - Pivot
a Not adjustable.
ELECTRONIC STABILITY PROGRAM
a Carry out calibration of the steering wheel angle
sensor.
Apply the after repair procedure:
- connect the diagnostic tool,
- select "Braking computer",
- go to repair mode,
- display the "Before/after repair procedure" for the
computer selected,
- select "Steering wheel angle sensor" in the "List of
components controlled by this computer" section,
- carry out the operations described in the "After re-
pair procedure" section.
30A-28
30A