Renault Laguna III Manual page 2292

POWER ASSISTED STEERING
Power-assisted steering pump: Removal - Refitting
D91, and V4Y
Special tooling required
Ms. 583 Pipe clamps.
Mot. 1448 Remote operation pliers for
hose clips.
Tightening torquesm
high pressure pipe
union on the power-
assisted steering pump
IMPORTANT
To avoid all risk of damage to the systems, apply
the safety and cleanliness instructions and opera-
tion recommendations before carrying out any
repair (see 36A, Steering assembly, Steering:
Precautions for the repair, page 36A-4) .
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Remove:
- the engine cover,
- the engine undertray bolts,
- the engine undertray,
- the front right-hand wheel (see 35A, Wheels and
tyres, Wheel: Removal - Refitting, page 35A-1) ,
- the front right-hand wheel arch liner (see Front
wheel arch liner: Removal - Refitting) (55A, Ex-
terior protection),
a Remove the accessories belt (see Accessories
belt: Removal - Refitting) (11A, Top and front of
engine).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
21 N.m
a Fit the tool (Ms. 583) on the low pressure pipe be-
tween the reservoir and the power-assisted steering
pump.
a Remove:
- the clip using the (Mot. 1448),
- the low pressure pipe (1) from the power-assisted
steering pump,
- the high pressure pipe (2) from the power assisted
steering pump.
a Insert the blanking plugs.
36B-13
36B
135266