Manual Gearbox Control Cable: Removal - Refitting - Renault Laguna III Manual

MECHANICAL COMPONENT CONTROLS
Manual gearbox control cable: Removal - Refitting
PK4 or TL4, and LEFT -HAND DRIVE
Tightening torquesm
gear control unit nuts
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Put the gear lever in neutral.
a Remove:
- the air filter box (see Air filter unit: Removal - Re-
fitting) (12A, Fuel mixture),
- the gear lever knob, by lifting it upwards,
- the central console (see Centre console: Remov-
al - Refitting) (57A, Interior equipment),
- the middle air distribution duct (see Rear air distri-
bution duct: Removal - Refitting) (61A, Heating
system).
a Cut the carpet at (1) .
a Unclip the wiring on the control unit at (2) .
Note:
Do not damage the control unit soundproofing.
a Remove the soundproofing (3) from the control unit.
21 N.m
a Unclip:
- the wiring on the reinforcement at (4) ,
- the left-hand air duct (5) .
a Remove:
- the driver's side dashboard lower trim (6) ,
- the reinforcement upper nuts,
- the reinforcement lower nuts (7) ,
- the reinforcement (8) .
122736
37A-69
37A
122729