Compensator: Removal - Refitting - Renault Laguna III Manual

Compensator: Removal - Refitting
4-WHEEL STEERING
Tightening torquesm
new bolts of the com-
pensator
new nut of the four
wheel drive actuator
eccentric bolt new nuts
by lining up the marks
IMPORTANT
Consult the safety and cleanliness advice and oper-
ation recommendations before carrying out any
repair (see 33A, Rear axle components, Rear
axle components: Precautions for the repair,
page 33A-1) .
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Switch off the ignition.
a Disconnect the battery (see Battery: Removal - Re-
fitting) (80A, Battery).
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Mark the position of the eccentric bolts (1) on the
compensator.
REAR AXLE COMPONENTS
105 N.m
84 N.m
90 N.m
128653
a Attach the four wheel drive actuator.
a Remove:
- the ball joint cover (3) ,
- the four wheel drive actuator bolt (4) .
a Attach the track rods.
a Remove:
- the bolts (5) from the track rods,
- the compensator bolts (6) ,
- the compensator (7) .
REFITTING
I - REFITTING PREPARATION OPERATION
a Always replace:
- the four wheel drive actuator nut,
- the track rod nuts,
- the compensator bolts.
a
Note:
Visually check the condition of the compensator
rubber bushes.
If a bush is damaged, replace the compensator.
a Clean the cage bolt threads of the compensator
bolts.
33A-56
33A
128332