Renault Laguna III Manual page 2194

Rear stub axle carrier: Removal - Refitting
4-WHEEL STEERING
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Remove the nut (4) of the ball joint (5) .
a Extract the ball joint (5) using the tool (Tav. 476).
a Mark the position of the eccentric bolt (6) on the rear
axle.
REAR AXLE COMPONENTS
128333
128334
a
WARNING
Certain vehicles possess a shim (11) on the stub
axle carrier yoke.
Do not throw away this shim.
If the shim (11) must be replaced, replace it with
a shim having the same engraved dimension.
The shim (11) is positioned with the engraved
face towards the front of the vehicle, on the front
side of the vehicle.
a Remove:
- the nut of the eccentric bolt (6) ,
- the eccentric bolt (6) ,
- the rear stub axle carrier bolt (7) ,
- the rear stub axle carrier.
REFITTING
I - REFITTING PREPARATION OPERATION
a Always replace the nuts of the stub axle carrier.
II - REFITTING OPERATION FOR PART
CONCERNED
a Refit the stub axle carrier, by fitting the ball joint of
the steering con rod.
33A-27
33A
133661