Hydraulic Distributor: Removal - Refitting - Renault Laguna III Manual

Hydraulic distributor: Removal - Refitting
M9R, and AJ0
Special tooling required
Mot. 1448 Remote operation pliers for
hose clips.
Equipment required
tweezers
Diagnostic tool
Tightening torquesm
hydra u l i c d i s t ributor
bolts
hydra u l i c d i s t ributor
housing bolts
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 415, 02A, Lifting equip-
ment).
a Remove:
- the battery (see Battery: Removal - Refitting)
(80A, Battery),
- the battery tray (see Battery tray: Removal - Re-
fitting) (80A, Battery),
- the front wheels (see Wheel: Removal - Refitting)
(35A, Wheels and tyres),
- the engine undertray bolts,
- the engine undertray,
- the front wheel arch liners (see Front wheel arch
liner: Removal - Refitting) (55A, Exterior protec-
tion),
- the front bumper (see Front bumper: Removal -
Refitting) (55A, Exterior protection),
- the headlights (see Headlight: Removal - Refit-
ting) (80B, Headlights),
- the front end panel (see Front end panel: Remov-
al - Refitting) (42A, Upper front structure).
a Drain:
- the automatic gearbox (see 23A, Automatic gear-
box, Automatic gearbox oil: Draining - Filling,
page 23A-29) ,
AUTOMATIC GEARBOX
8 Nm
8 Nm
- the cooling system (see Cooling system: Drain-
ing - Refilling) (19A, Cooling).
a Remove the nut (1) from the cooling hose.
a Separate the cooling hose (3) .
a Remove the air pipe bolts (2) at the intercooler inlet.
a Turn the intercooler air inlet pipe clip (4) at the turbo-
charger.
23A-35
23A
122430
113282