Renault Laguna III Manual page 2526

Heating resistors: Removal - Refitting
RIGHT-HAND DRIVE
Equipment required
Diagnostic tool
REMOVAL
I - REMOVAL PREPARATION STAGE
a Disconnect the battery (see Battery: Removal - Re-
fitting) (80A, Battery).
a Remove:
- the dashboard lower trim (see Dashboard lower
trim: Removal - Refitting) (57A, Interior equip-
ment),
- the front right-hand A-pillar air distribution duct (see
61A, Heating, Front footwell air distribution
duct: Removal - Refitting, page 61A-36) .
a On the driver's side, remove:
- the bolts (1) from the reinforcement plate,
- the reinforcement plate.
HEATING
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Disconnect the connector (2) from the heating resis-
tor.
a Remove:
- the heating resistor bolts (3) ,
- the heating resistor.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
a Refit the heating resistor.
a Connect the heating resistor connector.
127990
II - FINAL OPERATION.
a Refit, to the driver's side:
- the reinforcement plate,
- the front right-hand A-pillar air distribution duct (see
61A, Heating, Front footwell air distribution
duct: Removal - Refitting, page 61A-36) ,
- the dashboard lower trim (see Dashboard lower
trim: Removal - Refitting) (57A, Interior equip-
ment).
a Connect the battery (see Battery: Removal - Refit-
ting) (80A, Battery).
61A-29
61A
127989