Renault Laguna III Manual page 2440

MECHANICAL COMPONENT CONTROLS
Gear control unit: Removal - Refitting
D91, and AJ0, and LEFT-HAND DRIVE
Tightening torquesm
gear control unit nuts
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Place the gear selector in position R.
a Turn the ring on the gear lever knob (1) a sixteenth
of a turn.
a Remove:
- the gear lever knob, lifting it up and off,
- the central console (see Centre console: Remov-
al - Refitting) (57A, Interior equipment),
- the clip from the rear centre air duct above the
soundproofing,
- the rear centre air duct above the soundproofing.
a Place the gear selector in position D.
21 N.m
a Cut the carpet at (2) .
a Unclip the wiring on the control unit at (3) .
Note:
Do not damage the control unit soundproofing.
a Remove the soundproofing (4) from the control unit.
122726
a Unclip the wiring at (5) .
a Remove the airbag computer protector (6) .
37A-106
37A
122736
122734