Renault Laguna III Manual page 1917

Input shaft lip seal: Removal - Refitting
PK4
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 415, 02A, Lifting equip-
ment).
a Remove:
- the battery (see Battery: Removal - Refitting)
(MR 415, 80A, Battery),
- the battery tray (see Battery tray: Removal - Re-
fitting) (MR 415, 80A, Battery),
- the air filter box (see Air filter unit: Removal - Re-
fitting) (MR 415, 12A, Fuel mixture),
- the front wheels (see Wheel: Removal - Refitting)
(MR 415, 35A, Wheels and tyres),
- the starter (see Starter: Removal - Refitting) (MR
415, 16A, Starting - Charging),
- the front left-hand wheel arch liner (see Front
wheel arch liner: Removal - Refitting) (MR 416,
55A, Exterior protection),
- the front right-hand driveshaft (see 29A, Drive-
shafts, Front right-hand driveshaft: Removal -
Refitting, page 29A-7) ,
- the front left-hand driveshaft (see 29A, Drive-
shafts, Front left-hand driveshaft: Removal -
Refitting, page 29A-1) ,
- differential output seals (see 21A, Manual gear-
box, Differential output seal: Removal - Refit-
ting, page 21A-6) ,
- the radiator mounting cross member (see Radiator
mounting cross member: Removal - Refitting)
(MR 416, 41A, Front lower structure),
- the engine tie-bar (see Lower engine tie-bar: Re-
moval - Refitting) (MR 415, 19D, Engine mount-
ing),
- the front axle subframe (see Front axle subframe:
Removal - Refitting) (MR 415, 31A, Front axle
components),
- the gearbox (see 21A, Manual gearbox, Manual
gearbox: Removal - Refitting, page 21A-14) ,
- the clutch thrust bearing (see 20A, Clutch, Clutch
thrust bearing: Removal - Refitting, page 20A-
11) .
MANUAL GEARBOX
21A-58
II - REMOVAL OPERATION FOR PART
CONCERNED
a Use a drill bit with a diameter of 2.5 mm, to drill a
hole in the lip seal on the input shaft.
Note:
Do not drill too deeply as this risks damaging the
deflector positioned behind the input shaft lip
seal.
a Fit a bolt in the input shaft lip seal (1) .
a Remove the input shaft lip seal (1) with a pair of pli-
ers.
REFITTING
I - REFITTING PREPARATIONS OPERATION
a
Note:
When refitting the input shaft lip seal, take care
not to damage either the shaft or the contact sur-
face of the lip seal.
21A
20714