Front Hub Carrier Bearing: Removal - Refitting - Renault Laguna III Manual

FRONT AXLE COMPONENTS
Front hub carrier bearing: Removal - Refitting
K4M or K9K
Equipment required
Diagnostic tool
Tightening torquesm
brake calliper mounting
bolts
IMPORTANT
To avoid all risk of damage to the systems, apply
the safety and cleanliness instructions and opera-
tion recommendations before carrying out any
repair (see 31A, F ront axle components, Front
axle components: Precautions for the repair,
page 31A-1) .
WARNING
In order not to damage the brake hose:
- do not tension the hose,
- do not twist the hose,
- check that there is no contact with the surrounding
components.
WARNING
In order to prevent irreversible damage to the front
hub bearing:
- Do not loosen or tighten the driveshaft nut when
the wheels are on the ground.
- Do not place the vehicle with its wheels on the
ground when the driveshaft has been loosened or
removed.
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 415, 02A, Lifting equip-
ment).
105 N.m
Note:
it is necessary to lock the airbag computer in
order to unlock the steering column.
a Apply the before repair procedure using the Dia-
gnostic tool :
- connect the Diagnostic tool,
- select the airbag computer,
- go to repair mode,
- apply the "Before repair procedure".
a Remove the front wheel (see 35A, Wheels and ty-
res, Wheel: Removal - Refitting, page 35A-1) .
31A-38
31A