Renault Laguna III Manual page 1928

Automatic gearbox: Removal - Refitting
F4R, and AJ0
Special tooling required
Mot. 1390 Support for removal - refitting
of engine - gearbox assembly
Equipment required
workshop hoist
Diagnostic tool
Tightening torquesm
gearbox bell housing
bolts and nuts
converter nuts (pre-
tightening)
converter nuts (tighten-
ing)
converter nuts (tighten-
ing)
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 415, 02A, Lifting equip-
ment).
a Remove:
- the engine cover,
- the battery (see Battery: Removal - Refitting)
(MR 415, 80A, Battery),
- the battery tray (see Battery tray: Removal - Re-
fitting) (MR 415, 80A, Battery),
- the injection computer (see Diesel injection com-
puter: Removal - Refitting) (MR 415, 13B, Diesel
injection) or (see Petrol injection computer: Re-
moval - Refitting) (MR 415, 17B, Petrol injection),
- the air filter box (see Air filter unit: Removal - Re-
fitting) (MR 415, 12A, Fuel mixture),
- the engine undertray bolts,
- the engine undertray,
- the front wheels (see Wheel: Removal - Refitting)
(MR 415, 35A, Wheels and tyres),
- the front wheel arch liners (see Front wheel arch
liner: Removal - Refitting) (MR 416, 55A, Exterior
protection),
AUTOMATIC GEARBOX
44 N.m
22N.m
32N.m
44N.m
- the front right-hand driveshaft (see 29A, Drive-
shafts, Front right-hand driveshaft: Removal -
Refitting, page 29A-7) ,
- the front left-hand driveshaft (see 29A, Drive-
shafts, Front left-hand driveshaft: Removal -
Refitting, page 29A-1) ,
- the front bumper (see Front bumper: Removal -
Refitting) (MR 416, 55A, Exterior protection),
- the headlights (see Headlight: Removal - Refit-
ting) (MR 415, 80B, Headlights),
- the front end panel (see Front end panel: Remov-
al - Refitting) (MR 416, 42A, Upper front stucture),
- the catalytic converter (see Catalytic converter:
Removal - Refitting) (MR 415, 19B, Exhaust).
a Drain:
- the cooling system (see Cooling system: Drain-
ing - Refilling) (MR 415, 19A, Cooling),
- the refrigerant circuit (see Refrigerant circuit:
Draining - Filling) (MR 415, 62A, Air conditioning).
a Remove:
- the radiator mounting cross member (see Radiator
mounting cross member: Removal - Refitting)
(MR 416, 41A, Front lower structure),
- the rear suspended engine mounting (see Lower
engine tie-bar: Removal - Refitting) (MR 415,
19D, Engine mounting),
- the right-hand suspended engine mounting (see
Right-hand suspended engine mounting: Re-
moval - Refitting) (MR 415, 19D, Engine mount-
ing),
- the left-hand suspended engine mounting (see
Left-hand suspended engine mounting: Re-
moval - Refitting) (MR 415, 19D, Engine mount-
ing),
- the engine - gearbox assembly (see Engine -
gearbox assembly: Removal - Refitting) (MR
415, 10A, Engine and peripherals).
23A-10
23A