Front Wheel Alignment - Taylor-Dunn E0-455-24 Service And Replacement Parts Manual

E-455

FRONT WHEEL ALIGNMENT

WARNING
This section is one section of a complete service
manual. Before starting any procedure, read all
warnings and instructions that are located in the
Service Guidelines chapter.
1: Rotate the steering wheel until the pitman arm is
vertical, then tie off the steering wheel so that it
cannot rotate.
2: Loosen the four ball joint clamps on the front and rear
steering links.
3: Adjust the rear steering link so that the ball joint is 1/2
inch (12 mm) to the left of the center of the jack shaft.
4: Adjust the front steering link to position the front
wheels in the straight ahead position.
5: Tighten the four ball joint clamps on the front and rear
steering links.
6: Adjust the pitman arm steering stops so that the front
fork rotates approximately 45º to the left and right.
7: Reconnect the battery.
8: Test drive.
ME-455-04
Steering
Page 59