Adjust The Drive Chain - Taylor-Dunn SC-001-59 Operation, T Roubleshooting And Replacement Parts Manual

Transmission

ADJUST THE DRIVE CHAIN

NOTE: A small amount of oil may come out when the drive motor mounting
6. Place a small oil drain pan under the chain case.
7. Loosen but do not remove the three drive motor
mounting nuts.
8. Loosen the adjusting screw jam nut.
9. Raise the drive wheels off of the ground.
10. Tie the vehicle in place so that it cannot move.
bolts are loosened.
1. Make sure the key-switch is in the "OFF" position, then remove
the key.
2. Place the forward-reverse switch in the center "OFF" position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
Always use a lifting strap, hoist, and jack stands, of adequate capacity
to lift and support the vehicle. Failure to use lifting and support devices
of rated load capacity may result in severe bodily injury.
Tie the vehicle to an immovable object to prevent the vehicle from
moving in forward or reverse. Failure to securely tie the vehicle may
result in unexpected vehicle movement resulting in severe bodily
injury or property damage.
Transmission Page 2