2.3.4 Connector 'J3 | POWER IN' DC Power Mains
FOR SAFETY REASONS, MAKE SURE YOU KNOW THAT THE 'J3 | POWER IN'
DC POWER CONNECTION PIN ASSIGNMENTS ARE DIFFERENT FOR EACH
LPOD UNIT. YOU MUST USE THE CORRECT PIN ASSIGNMENTS.
INCORRECT USE OF PIN ASSIGNMENTS CAN RESULT IN PRODUCT DAMAGE
OR PERSONAL INJURY.
For all LPOD models, the prime power input requirement is 38 to 72 VDC. The total power
required from the prime power supply depends on the model used. See Sect. 1.5 Summary of
Specifications for more information.
2.3.4.1
PS 1 'J3 | POWER IN' DC Power Main
Pin
A
B
C
D
System Connectors, Installation, and Startup
Low Power Outdoor (LPOD) Amplifier/Block Up Converter (BUC)
The mating connector specification and the pin assignments (Table 2-4) specific
to the PS 1 DC power interface are as follows:
Mating Connector:
CEFD P/N CN/STPG04F01 (Glenair IPT06E-12-4-SSR-F7)
Table 2-4. PS 1 'J3 | POWER IN' Pin Assignments
V+
GND
V-
NO CONNECT
Description
2–8
Revision 15
MN-LPOD