Connector 'J1 | Lband In' Or 'J1 | Tx In; Connector 'J2 | Rf Out; Table 2-1. 'J2 | Rf Out' Interface Type - Comtech EF Data LPOD Series Installation And Operation Manual

2.3.1 Connector 'J1 | LBAND IN' or 'J1 | Tx IN'

2.3.2 Connector 'J2 | RF OUT'

FOR SAFETY REASONS, NEVER LOOK DIRECTLY INTO THE WAVEGUIDE
OUTPUT.
The 'J2 | RF OUT' connector may be a waveguide or coaxial interface – the type of interface
used depends on the LPOD model and/or frequency range of the unit. See Table 2-1 and
Figure 2-2, Figure 2-3, or Figure 2-4.
Unit
PS 1
PS 1.5
PS 2
System Connectors, Installation, and Startup
Low Power Outdoor (LPOD) Amplifier/Block Up Converter (BUC)

Table 2-1. 'J2 | RF OUT' Interface Type

Frequency Band
Type 'N' Female (Standard)
C
CPR137G (Optional)
X CPR112G (Waveguide)
Ku WR75 (Waveguide)
C CPR137G (Waveguide)
X CPR112G (Waveguide)
Ku WR75 (Waveguide)
C CPR137G (Waveguide)
X CPR112G (Waveguide)
Ku WR75 (Waveguide)
The RF input connector is a Type 'N' female
connector. Labeled 'J1 | LBAND IN' on the PS 1 and
PS 1.5 models or 'J1 | Tx IN' on the PS 2 model,
typical input levels (-30 dBm), depend on desired
output power and unit attenuation. To prevent damage
to the LPOD, RF input levels should not exceed +15
dBm.
Output Type
2–5
Revision 15
Figure
2-3
2-4
2-5
MN-LPOD