Remote Commands And Queries - Comtech EF Data LGAN Installation And Operation Manual

5.5

Remote Commands and Queries

Table Indexes:
Notes:
1) Index Columns – Where Column 'C'=Command, and Column 'Q'=Query, columns marked 'X' designate the instruction code as
Command only, Query only, or Command or Query. Where CODE=XXX, this indicates a priority command.
2) In the tables that follow, the following codes are used in the 'Response to Command' column (per Sect. 8.5.5):
= Message ok
? Received ok, but invalid arguments were found.
^ Message ok, but unit is in Ethernet mode.
Serial Interface Operation
# Message ok, but unit is not in Remote mode.
~ Time out of a pass-through message, either to via EDMAC or to a local
ODU.
5–9
LGaN
Revision 0
MN-LGAN