2.2.4
Test print mode (test mode 04)
The embedded test pattern can be printed out by keying in the following codes in the test print mode
(04).
<Operation procedure>
[0][4]
(Code)
[POWER]
Notes:
1. When an error occurs, it is indicated on the panel, but the recovery operation is not per-
formed. Turn OFF the power and then back ON to clear the error.
2. During test printing, the [CLEAR] button is disabled when "Wait adding toner" is displayed.
Code
111
Primary scanning direction 33 gradation steps
113
Secondary scanning direction 33 gradation steps
142
Grid pattern
e-STUDIO200L/202L/230/232/280/282 ERROR CODE AND SELF-DIAGNOSTIC MODE
[START]
Types of test pattern
Operation
[CLEAR]
Continuous
Test Printing
Error diffusion
Error diffusion
Pattern width: 2 dots, Pitch: 10 mm
2 - 42
[POWER] OFF/ON
(Exit)
Remarks
June 2004 © TOSHIBA TEC