Target Group - Siemens SIDOOR ATD4 W Series System Manual

Information regarding third-party products
Note
Recommendation relating to third-party products
This document contains recommendations relating to third-party products. Siemens accepts the
fundamental suitability of these third-party products.
You can use equivalent products from other manufacturers.
Siemens does not accept any warranty for the properties of third-party products.
1.2.2

Target group

The system manual is intended for:
• Assemblers
• Commissioning engineers
• Operators
• Service personnel
• Project engineers of machine protection doors
Revision of the system
manual
06/2016
01/2017
06/2018
11/2018
09/2020
ATD4xxW for industrial applications
System Manual, 06/2022, A5E51901827B AA
Change
First edition
Revision of MDG700 NMS
Changes according to firmware update V1.12
Note:
Read the instructions in the following sections before updating to V1.12:
• Deactivation of the service buttons during emergency stop (as of V1.12)
(Page 116)
Change for motors
Integration of changes from document "Release Notes Firmware ATD4xxW
V1.13".
Changes according to firmware update V1.14.
Note:
After the update to V1.14 all parameters are set to default values. User-spe‐
cific settings have to be set again.
Introduction
1.2 About this manual
13