Approaching An Interruption Point Again; Entering A Search Target - Siemens SINUMERIK 840D sl Operating Manual

3.6.2

Approaching an interruption point again

Requirement
A program was selected in "AUTO" mode and interrupted during execution with "Reset".
Proceed as follows
3.6.3

Entering a search target

Enter the program point which you would like to proceed to in the "Search indicator" window.
Requirement
The program is selected and the control is in Reset mode.
Screen form
Each line represents one program level. The actual number of levels in the program depends
on the nesting depth of the program.
Level 1 always corresponds to the main program and all other levels correspond to
subroutines.
You must enter the target in the line of the window corresponding to the program level in
which the target is located.
For example, if the target is located in the subroutine called directly from the main program,
you must enter the target in program level 2.
The specified target must always be unambiguous. This means, for example, that if the
subroutine is called in the main program in two different places, you must also specify a
target in program level 1 (main program).
HMI sl Universal
Operating Manual, 11/2006, 6FC5398-6AP10-1BA0
1. Press the "Interrupt point" softkey.
The interruption point is loaded.
2. Press the "Start search" softkey.
The search is started. Your specified search mode will be taken into
account.
The search screen closes. The current block will be displayed in the
program window as soon as the target is found.
3. Press the "CYCLE START" key twice.
The program will continue executing continue from the interruption
point.
Machine the workpiece
3.6 Starting execution at a specific point
65