7.0 Link Configuration - Trango Systems TrangoLINK GigaPlus User Manual

7.0 Link Configuration

This section describes the step by step process of configuring a link and making sure it is
working properly before installing and putting live traffic on the system.
This section covers basic link establishment for a single link. This setup may be done on
the bench or in the field. It is highly recommended that the basic link setup be done on
the bench to avoid problems when installing the equipment.
Special bench test setups that provide mounting and fixed or variable attenuation
between the RF ports of the units can be obtained from Trango for this purpose. All
steps given should be performed on both ends of the link.
IMPORTANT NOTE: If the link was factory preconfigured at Trango before shipment,
this section can be skipped since the proper settings are already in place inside the
radio units.
Only the IP addresses need to be changed and the Opmode needs to be enabled at
both ends.
It is still recommended to set the date and run the status save command to record the
known good state of the link after installation, alignment and link testing
82
Trango Systems, Inc. GigaPlus User Manual Rev 3.1