Sync; Sync_State - Trango Systems TrangoLINK GigaPlus User Manual

sync

SYNTAX
DESCRIPTION

sync_state

SYNTAX
Trango Systems, Inc.
utilization.
sync
Default: N/A
Configuration Storage: N/A
sync without any parameter will perform synchronization procedure
between Active and Standby unit
sync command only allowed to be initiated on Active unit.
sync is used to perform synchronization procedure to sync up
configuration parameters between Active and Standby units. There
are some parameters which are independent of utype and therefore,
will not be synchronized with this command. The following
commands are the ones that, if executed, prevent achieving sync
with the Standby unit:
Alarm, alignment, cableloss, fanctrl, ibm, ipconfig, license key,
loopback mode, opmode, tftpd and traps.
sync_state
Default: N/A
Configuration Storage: N/A
sync_state without any parameter will display synchronization status
GigaPlus User Manual Rev 3.1
192