Config Node - Trango Systems TrangoLINK GigaPlus User Manual

temp
tftpd
threshold
trap
uptime
Utype
version
voltage

Config Node

Users can enter this node by typing in the command "config" from the view node. They
will be prompted for a password and after successful authentication users enters the
config mode. All configuration settings can be changed here.
 All the commands entered without any parameters returns the current
configured values and are similar to "view" node.
 All configuration changes are applied immediately and don't require any reboot
(except "speed" in which the settings are applied immediately, but it does
require reboot after save).
 All configuration changes have to be saved in order to be persistent across
reboot. A single "save" command will save all configuration changes
 Users can go back to the "view" node by typing in the command exit
Config Node Command List
CLI
acm
alarm
alignment_mode
atpc
ber
Trango Systems, Inc.
Display IDU and ODU temperature
Display tftp server (tftpd) status
Display threshold status
Display SNMP Trap IP configuration
Display system uptime
Display the current unit type (Active or Standby)
Display IDU/ODU Software version
Read voltage values from PIC
Ranges
enable <on|off>, mod
Alarm 1 and 2 <on|off>
<on|off>
enable <on|off>, max_power,
step_size
<1-99> seconds
GigaPlus User Manual Rev 3.1
Default Value
Off
Off
Off
Off
N/A
140