Trango Systems TrangoLINK GigaPlus User Manual page 126

SUCCESS
Verify the settings are correct.
(CLI-config)# ibm
IBM Enable:
IBM Tagging:
IBM Vlan ID:
IBM IP address:
IBM Netmask:
Verify the connection to the other end of the link by entering the debug node and using
the ping command inside the GigaPlus. In the example, the other end of the link has an
IP address of 172.16.1.1.
(CLI-config)# debug
Ping the other side of the link using the ping command from within the debug node of
the radio.
debug> ping 172.16.1.1
PING 172.16.1.1 (172.16.1.1): 56 data bytes
64 bytes from 172.16.1.1: seq=0 ttl=64 time=6.672 ms
64 bytes from 172.16.1.1: seq=1 ttl=64 time=1.001 ms
64 bytes from 172.16.1.1: seq=2 ttl=64 time=0.979 ms
--- 172.16.1.1 ping statistics ---
3 packets transmitted, 3 packets received, 0% packet loss
round-trip min/avg/max = 0.979/2.884/6.672 ms
Note: Besides ping , It should be noted that from the debug prompt a telnet session
can be run to configure the far end if desired. It should be kept in mind that any
Trango Systems, Inc.
off
off
100
172.16.1.2
255.255.255.0
GigaPlus User Manual Rev 3.1
126