License - Trango Systems TrangoLINK GigaPlus User Manual

DESCRIPTION

license

SYNTAX
DESCRIPTION
Trango Systems, Inc.
and remote IP address.
ipconfig is a system-level command.
This command is used to set IP address, subnet mask and default gateway
for the management port of the system. The system MAC address can be
displayed via this command. The change takes place effect immediately.
Ipconfig ip: Both IP and netmask parameters must be present.
Ipconfig gateway: Configure the default gateway IP. Valid for both Inband
and Out-of-band port.
license Display license enable status
license_speed <1-2> <speedkey>
license_tdm <tdm_key>
Default: N/A
Configuration Storage: No
License key command is used to set the license required for using higher
speed (> 100Mbps) on the radio. Speed key 1 enables speed up to
200Mbps and speed key 2 enables Max speed. Please refer to the actual
speed/modulation/channel width combination for valid profiles.
GigaPlus User Manual Rev 3.1
167