Trango Systems TrangoLINK GigaPlus User Manual page 61

(CLI-config)#
(CLI-config)# tftpd on
tftpd: on
SUCCESS
(CLI-config)#
6) Open a command prompt (or other CLI interface) window on the PC where the
new firmware is being stored and access the directory that you extracted the
firmware files.
C:\CD Firmware
C:\Firmware
7) Using the TFTP command line tool, upload the firmware file. The tftp syntax and
an example are below.
TFTP [-i] host [GET | PUT] source [destination]
C:\firmware>tftp -i 192.168.100.100 put idu_gigaplus_v13.tar.gz
Transfer successful: 1951744 bytes in 15 seconds, 130116 bytes/s
8) Once the file has been transferred successfully, log back into the unit and apply
the updates into the FLASH memory using the bootimage upgrade command
from the config mode. Each firmware needs to be upgraded on the unit using the
bootimage upgrade command.
(CLI-config)#
(CLI-config)# bootimage upgrade idu
NOTE: THE BOOTIMAGE UPGRADE COMMAND MUST BE ALLOWED TO
COMPLETE BEFORE THE SYSTEM IS REBOOTED. IF THE SYSTEM IS REBOOTED
DURING THE WRITING OF THE IMAGE TO FLASH,
CORRUPT – WAIT FOR THE SUCCESS INDICATION BEFORE PROCEEDING.
If the ODU firmware was also being upgraded, the ODU file would be transferred
to the GigaPlus ODU using the same method as the IDU file. After loading the
file, the bootimage upgrade odu command would be used to write it to FLASH.
Trango Systems, Inc. GigaPlus User Manual Rev 3.1
THE FLASH MAY BECOME
61